Page 1 of 1

Yoke zone in the way

PostPosted: Tue Mar 14, 2017 6:25 pm
by toliverez
There are two selection zones for the yoke in the C172. It has a zone outlining where the yoke would be, and also where the yoke attaches to the panel. If you're using the gaze function, it makes actuating the switches around the yoke near impossible because of this extra and useless zone for the yoke is HUGE and in the way. Is there any way to remove this zone since there it already has a better one on the actual panel? Thanks!

Xplane pb15