Page 1 of 1
RESOLVED -Recenter Rift In P3D
Posted:
Mon May 09, 2016 2:02 pm
by rj16066
How do you recenter your Hud in Rift while in Sim? I also have the leap motion working but cannot figure out what to push to recenter my Rift HUD
Update:
Started using FSUIP4 and now it is working. I recommend not to use the Target software with your TM Warthog in this sim.
Thanks for the reply
Cheers
RJ
Re: Recenter Rift In P3D
Posted:
Mon May 09, 2016 3:04 pm
by Bruce_C
To recenter your view you need to bind a key or button in the Fly Inside settings, not sure what you mean about the HUD?
Re: Recenter Rift In P3D
Posted:
Mon May 09, 2016 3:14 pm
by rj16066
Just ment the RIft HMD.. Sorry.. So there is a key binding location in the program? I will go look
Thanks for the reply.
Cheers
RJ
Re: Recenter Rift In P3D
Posted:
Tue May 10, 2016 5:20 pm
by admin
There's a key-binding under FlyInside Bindings. You can also just give your headset a gentle-ish tap and FlyInside will recenter for you
Re: RESOLVED -Recenter Rift In P3D
Posted:
Thu May 26, 2016 7:34 am
by Simon853
If I press the button to re-centre the HMD, I find it resets it to a position that's noticeably off from the default VC viewpoint, about 6 inches to the left and up of where it should be. I find myself moving about in my chair in 3 dimensions repeatedly pressing the reset until it looks about right. Any ideas?
Si
Re: RESOLVED -Recenter Rift In P3D
Posted:
Thu May 26, 2016 7:50 am
by Bruce_C
I'd recommend binding some joystick buttons (ideally a hat switch) to the 'move eyepoint' commands either in FSX or using FSUIPC (highly recommended)
It's also possible to set a default VC position by adjusting the aircraft.cfg file for each specific aircraft but it's not something I'm familiar with.
HTH
Bruce
Re: RESOLVED -Recenter Rift In P3D
Posted:
Thu May 26, 2016 9:35 am
by Simon853
I think I know what happened with my flights:
I tend to fly helicopters so often end up landing and saving flights on sloping terrain. I suspect when the flight reloads the eye point is calculated based upon the cfg eye point 3D offsets from the aircraft datum without taking the resting attitude into account.
I just saved a flight at an airport (which are all always level in P3D/FSX), reloaded and it was fine.
Si