New user and potential customer here. I've been trying the demo version with P3D 3.3. With a pretty powerful rig (overclocked 4790k and GTX 970 with latest driver), my FPS drops to 30 or below if I increase the resolution above the minimum. Also, I have terrible flickering--nausea inducing even--unless I enable SGSS in Nvidea Inspector; however, doing so drops the FPS too low (35 or less even at lowest resolution).
I have tried every combination of anti-aliasing on and off I can think of (both in P3D and Flyinside). In order to obtain 60 FPS or higher with FlyInside, the only thing I have found that works is to set the resolution at minimal and to disable SGSS, Oh, I've also tried default and add-on aircraft with no difference. I'm not running any add-ons either.
Basically, I am looking for some guidance on what settings to use to increase the resolution and reduce flickering to acceptable levels. My P3D settings are not the issue. I have experimented with dropping everything in P3D to low or mid settings for autogen, water, etc., but that has little or no effect. I normally maintain 60+ FPS in P3D, with 100+ if I drop the settings.
edit: I should mention that I'm using the latest (1.52) of FlyInside. After watching several review videos, my experience is definitely atypical. Frustrating that I can't figure out why.
Thanks for any help.