Page 1 of 1

Integrated Graphics configuration

PostPosted: Tue Jul 19, 2016 6:48 pm
by RetiredFE
Tony or Bruce, In my bios setup, I have the following configuration. I was wondering if you could tell me if these are correct and if changing either of them may affect the flickering I am getting. I don't want to change anything as I don't know what will happen. Would like your opinion.
Integrated Graphics Configuration:
2 Settings:
1. Initiate Graphic Adapter - currently set to (PEG)
Other option is - IGD (Integrated Graphics Display)
2. IGD Multimonitor - currently set to Disabled
Other option is Enabled - In the comment box it says "Enables/Disables the multiscreen output from integrated graphics and external graphics card.

Just wondering if #2 is set correctly in your opinion, and if it might make a difference if I changed this setting.
Thanks,
Rodger

Re: Integrated Graphics configuration

PostPosted: Wed Jul 20, 2016 1:59 am
by Tony
Can i have the name and model number of your motherboard Rodger so I can check for you mate ;)

Tony

Re: Integrated Graphics configuration

PostPosted: Wed Jul 20, 2016 2:36 am
by Bruce_C
Without looking at specifics for your MoBo:

PEG stands for PCI Express Graphics which will be the type of connection for you main graphics card so should be fine. I think IGD Multimonitor with be Integrated Graphics (on board your motherboard) which you're not using so no need to enable multimonitor support.

Bruce

Re: Integrated Graphics configuration

PostPosted: Wed Jul 20, 2016 8:13 am
by RetiredFE
Thanks guys, I think I'll try something that I haven't before and that is renaming the fsx.config file to see what happens.

Re: Integrated Graphics configuration

PostPosted: Wed Jul 20, 2016 8:47 am
by RetiredFE
RetiredFE wrote:Thanks guys, I think I'll try something that I haven't before and that is renaming the fsx.config file to see what happens.


And that didn't work, either........