The Home of FlyInside Flight Simulator FFS FSX P3D and X-PLANE Message Board

Hi, im using FI 1.6 and like before i have a offset between the switches and the position leap motion / the new ui for setting switches and turning knobs.
Using the Aerosoft A320/321. Is there a way to adjust this somewhere?
A picture of this problem was posted in another thread that named "offset in Leap Motion"
Hitting the switches/knobs with the mouse makes no problems.
Thanks Thomas

Hi Thomas,

I thought I had this bug fixed in 1.6, but apparently it's still around under some conditions

Could you take a screenshot so that I can see how extreme the glitch is for you, compared to older versions? Also, could you confirm whether you also see this in a stock aircraft like the B737?

Thanks,
Dan

Hi Dan,
the Air King 350 from P3D fits perfectly.
I attached an screenshot of the Airbus.
is there a xyz-setting i can correct anywhere in the configs?

Sorry, there isn't a useful setting for that at the moment. I definitely need to correct this though

Any chance that you could take a screenshot of the same controls, at an airport near the equator, one at KBOS, and one close to the north pole? Also, could you check whether the offset changes as you rotate the aircraft's heading?

The info is much appreciated, I need to figure out if this bug is similar to an older one, or a new bug.

Hi Dan,
no matter what latitude or heading i´m on, the offset is everytime the same. See picture below.
Hope it helps, seems to be a new bug. In one plane it fits, in others there is a offset.
Any news appreciated,
Greetings Thomas

Hi Dan,
any news about that?
I will surely like to beta-test for you if you provide me a link to the corresponding beta-download when available.
Greetings Thomas

Hi Tom,

You should have access to the beta forum now. I figured out what was going on here and have a fix!

Thanks,
Dan