Hi,
This topic follows my crashing problem which was going nowhere. I decided to do a clean install of P3D v3.4 and ditto for Flyinside v1.81.
I've been testing with the default King Air 350 in a virgin P3D. Flying went well, both on my monitors independent of FlyInside, and via FlyInside v 1.81.
I installed my Flight1 GTN750, and added it to the King Air, with the following results:
King Air on runway at EGPF...........OK.
Open GTN750...........................OK.
Select "Direct To"......................OK.
Choose Airport EGPK..................OK
Move to 750''s Map.....................Freeze.
Perhaps 15 seconds from opening GTN750 to Freeze!
Restarting FlyInside 1.81 results in an error message to the effect that FlyInside cannot connect to Oculus on the current Adaptor.
I restarted the Computer, uninstalled the GTN750 and restored the King Air's panel to default. FlyInside then started P3D, and a test flight was carried out successfully.
As the helplines say, "The GTN750 is very important to me", so I'm willing to do any testing which Dan or anyone else might suggest to eliminate this problem.
Regards, Jim