Page 2 of 2

Re: Crash on new build of flyinside

PostPosted: Sat Oct 14, 2017 6:55 am
by davidcollett5
Fixed! disabled HRD lighting in 3pd settings ( even tho flyinside had asked to disable it ) and boom working fine! so smooth!

Thanks for the great product and help! thanks tony! now time to go buy the TDFI 717 and really try her out

david

Re: Crash on new build of flyinside

PostPosted: Sat Oct 14, 2017 7:00 am
by Tony
Hmmm strange mate, HDR should work just fine ???

Re: Crash on new build of flyinside

PostPosted: Wed Oct 25, 2017 9:10 pm
by AKA102
exactly the same problem except HDR was disabled by fly inside, I tried toggling but no joy. Any more ideas?

Re: Crash on new build of flyinside

PostPosted: Mon Oct 30, 2017 4:50 pm
by AKA102
I have the latest version of Flyinside, P3dv4.1 running on windows 10. The processor is a i7-7700k OC at 4.9GHz with an 1080Ti Gpu. Drivers all updated today. P3dv4.1 started with Fly inside and loads completely but once the airport graphics are finalized, the rendering error occures. The log is attached.....somewhere on the forum I think I saw something about resetting the shaders, but now I can't find it. For the record, I do have PTA and Envtex installed, not using weather for this test.

While I must admit VR has been a big disappointment, the resolution simply isn't good enough to even find an airport at 5 miles. I am hoping that FlyInside will improve on this, but at this stage I can't use it to find out. Also as a note: Trying Aerofly FS2 didn't result in that big of an improvement from P3Dv4.1 native. Any suggestions and help would be appreciated.

Thank you
Henry

Re: Crash on new build of flyinside

PostPosted: Mon Oct 30, 2017 5:07 pm
by Stevil
Can you try to remove the 2nd monitor?
Is your HMD plugged into the 1080ti?

Re: Crash on new build of flyinside

PostPosted: Mon Oct 30, 2017 5:45 pm
by Tony
This post may help some..... = viewtopic.php?f=14&t=6090&p=26206&hilit=shaders#p26206

Also just to confirm....HDR is disabled in this release but is on the future map to be added, sadly no timescale.

Re: Crash on new build of flyinside

PostPosted: Mon Oct 30, 2017 6:55 pm
by AKA102
Thanks for the quick replies....I am currently away from the computer but I will disconnect the second monitor and I will take Tony's suggestions as well. I did confirm that HDR was off. FI did in fact resize and turn off HDR at the beginning of the program. Before I left I also confirmed that after the error, P3dv4.1 froze but not the computer.

I will try tonight and report back.

Thanks,
Henry

Re: Crash on new build of flyinside

PostPosted: Fri Nov 03, 2017 5:10 pm
by AKA102
No Joy.
I cleaned out the shaders, removed PTA and Envtex, and used no weather. I actually loaded the airport this time, but crashed as soon as I tried to do anything. I have read the forum and see others with similar problems but really no solutions. For me, FI just isn't working.....VR, while terrible on P3Dv4.1 runs fine native, the resolution is just unacceptable, and VR works fine in AeroSky FS2, still with bad resolution, but nothing in FI.

Henry