The Home of FlyInside Flight Simulator FFS FSX P3D and X-PLANE Message Board

I'm finding when I use World Traffic 3 , I'm unable to close the flight setup window .
Cant even drag it.
Have the same issue with the WT3 Radar as well.
The only way to remove the windows is to disable the plug-in.

This doesn't happen if running Xplane outside of Flyinside.

Not sure if its related, but the Flyinside window is always just off my monitor screen to the left, its not a physical monitor setup issue.
Once I managed to expand it to fill my monitor screen and I was able to close the WT3 windows, be dammed if Ive manage to replicate this.

Any help would be appreciated

I've been using World Traffic 3 since it came out and although i haven't had any issues closing that dialogue for a while, i do have vague recollections of having an issue when it was so close to the top of the screen that the drop down XP menu covered the top bit where the close window "x"s are.

Is this the issue you are having?

Hi, I'm able to click on "X", but doesn't seem to close the box.

Quit annoying as the mouse in the virtual cockpit is obstructed by WT3 box covering half the cockpit

There can be a delay before the close works, when that dialogue is actually doing something like generating flights or ground routes, so have you been back and tried to close it again. Also, and you have probably tried this, but experimenting with exactly where you place the point of the mouse cursor when you click might bring some success. For example, with the Xplane map and ATC Windows, I have to point just below the close buttons to get the windows to close.

Ive found a cure.

Basically flyinside wasn't running in fullscreen mode correctly, it was windowed.

So I went into Settings- Graphics- monitor configuration-Monitor Usage, and reselected "Full Screen Simulator"

This then expanded the flyinside desktop window to near full screen, still has a gap at the bottom showing the desktop, anyways its seems to fixed the issue with WT3 boxes gluing themselves.