F.I. does not seem to recognise FSX or ViseVersa

[Tony]

And this mate just checking ? = FlyInside FSX doesn't support SLI/Crossfire. Be sure to configure FSX to use a single GPU before trying to run FlyInside if you have a multi-GPU setup.

Tony

[admin]

Is there any chance you have two different copies of FSX installed, and FlyInside only installed to one of them (and you're using the other)? Check in your "FSX" folder, and make sure that there is both a "DCOC" folder and a "d3d9.dll" file.

Next, try right clicking on the "d3d9.dll" file (this is how FlyInside attaches), and making sure that it is unblocked.

Finally, whether you have any anti-virus software installed which could be locking down FlyInside. Make sure that it isn't quarantining any of the files in your FSX folder.

When it works, FlyInside will activate automatically if your Rift is turned on. Even if there's a bug, you'll generally get an error message or crash, rather than FSX just running normally. You should at least see "Cloud mode" appear on your Rift. Something silly is going on here

Let me know how this works out for you!

[Sharkku]

And this mate just checking ? = FlyInside FSX doesn't support SLI/Crossfire. Be sure to configure FSX to use a single GPU before trying to run FlyInside if you have a multi-GPU setup.

Tony

Ah, there you have it! =)

[Voodoo]

and I am just getting the yellow LED indicator on the rift. No visual out of the eyepieces.


WILCO!

[Voodoo]

How do I set up for only 1 GPU?

[Tony]

Can you pull one from your machine and try again mate ? (ignore my post and listen to the expert below)

Tony

[admin]

I wouldn't go pulling graphics cards out yet

Usually even if SLI is causing conflicts, FlyInside will throw an error or show something weird on the Rift. I think an anti-virus conflict/lock-down is a much more likely cause of FlyInside not doing anything at all. Once you have FlyInside loading, but not working, that's when I'd start messing with SLI. Usually it is enough to set FSX to single-GPU in the NVIDIA Control Panel.

[Voodoo]

OK, no DCOC in FSX but the .dll you wanted is there.

[Voodoo]

I have DCOC for P3D v2.5 working on P3D.

[admin]

No DCOC folder? I'd run the FlyInside installer again, and make sure that it's installing to the right place...

EDIT: FlyInside uses a DCOC folder to hold some of its components. It's unrelated to the DCOC software, just named that because I originally code-named this project as DCOC after the Prepar3D software.